TM 5-3805-261-20
BODY, CAB, HOOD AND HULL MAINTENANCE.
13-23.
Tool Box. (Sheet 2 of 2)
REMOVAL
1.
Open lock (1) and cover (2) of tool box (7,
Figure 13-69) at front of vehicle.
2.
Remove two nuts (3) and washers (4) from
bottom of tool box (7) at front corners.
3.
Remove four bolts (5) and washers (6) from
inside tool box (7) at each corner.
4.
Remove tool box (7).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Install tool box (7, Figure 13-69).
2.
Install four washers (6) and bolts (5).
3.
Install two washers (4) and nuts (3).
4.
Close and lock cover (2) with lock (1).
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 13-69.
End of Task
13-85