TM 5-3805-261-20BODY, CAB, HOOD AND HULL MAINTENANCE.13-25.RearBumper.(Sheet 2 of 3)REMOVAL1.Remove cotter pin (1), pin (2) and clevis pin(3, Figure 13-71). Discard cotter pin (1).WARNINGWeight of bumper is approximately100 lbs. Use adequate hoist and slingfor lifting. Failure to follow thisprocedure may cause INJURY. If youare injured, seek medical aidimmediately.2.Install 3/8 inch-16NC eyebolts into topcenter hole in bumper (8, Figure 13-72).3.Attach hoist and sling and take up slack.4.Remove four bolts (4) and washers (5,Figure 13-73).5.Remove four bolts (6) and washers(7).6.Remove bumper (8) by sliding out from rearframe.7.Remove hoist and sling.CLEANINGClean all parts. Refer to Chapter 2.INSPECTIONInspect all parts. Refer to Chapter 2.Figure 13-71.Figure 13-72.Figure 13-73.Go to Sheet 313-89
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
