TM 5-3805-261-20
STEERING MAINTENANCE. (cont)
11-2.
Supplemental Steering Pump and Mounting. (Sheet 2 of 3)
REMOVAL
NOTE
All hose and tube assemblies must
be tagged before disconnecting to
aid in installation. Cap all hose and
tube ends and plug all open hydraulic
ports to prevent contamination.
1.
Disconnect two hydraulic tubes (1, Figure
11-3)
from
top
front,
left
of
engine
compartment.
2.
Remove four bolts (2), washers (3) and
supplemental steering pump (4, Figure 11-
4).
3.
Remove and discard gasket (5, Figure 11-
5).
4.
Remove coupling (6, Figure 11-6).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
1.
Inspect supplemental steering pump (4).
Replace if case is damaged or threads on
hose coupling are stripped.
2.
Inspect all other parts. Refer to Chapter 2.
Figure 11-3
Figure 11-4
Figure 11-5
Figure 11-6
Go to Sheet 3
11-6
