REMOVAL (cont.) - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
144

TM 5-3805-261-20 FUEL SYSTEM MAINTENANCE. (cont.) 6-15. Injection Lines. (Sheet 3 of 6) REMOVAL (cont.) 7. Remove screw (12) and two clamps (13) from bracket (18) and injection line assembly (14, Figure 6-36). 8. Disconnect injection line assemblies (14 and 15) from injection nozzles. 9. Remove injection line assemblies (14 and 15) from injection pump. 10. Remove bolt (16), washer (17) and bracket (18) from top of engine. CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2 INSTALLATION 1. Install bracket (18), washer (17) and bolt (16, Figure 6-36) to top of engine. 2. Connect injection line assemblies (15 and 14) to injection nozzles on top of engine. Do not tighten injection line assemblies (15 and 14). 3. Install two clamps (13) on injection line assembly (14) and bracket (18). 4. Install screw (12). Figure 6-36. Go to Sheet 4 6-52

Privacy Statement
Press Release
Contact