TM 5-3805-261-20
FUEL SYSTEM MAINTENANCE.
6-15.
Injection Lines. (Sheet 2 of 6)
REMOVAL
CAUTION
Injection nozzles must not be allowed
to turn when disconnecting injection
line assemblies. Hold injection nozzle
with a wrench to prevent damage to
nozzles.
1.
Remove two screws (1) and four
clamps
(2)
from
injection
line
assemblies (5 and 6, Figure 6-33) in
top of engine.
2.
Remove screw (7) and two clamps (8).
NOTE
Cap all injection nozzles and injection
pump ports to prevent contamination.
Tag and cap all injection lines.
3.
Remove bolt (3), washer (4), and
bracket (9) from cylinder head.
4.
Disconnect injection line assemblies (5
and 6) from injection nozzles.
5.
Remove injection line assemblies (5
and 6) from injection pump.
6.
Remove two screws (10) and four
clamps
(11)
from
injection
line
assemblies (14 and 15, Figure 6-35)
on top of engine.
Figure 6-33.
Figure 6-34.
Figure 6-35.
Go to Sheet 3
6-51
