TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-02 Left Steering Cylin- 10.
Resistance Less Than 5.0 Ohms -
der Position Sensor Data
sure resistance between rear
Proceed to Test Step 7.
Erratic, Intermittent or Incor-
chassis wiring harness connector
Resistance 5.0 Ohms or Greater -
rect - Continued
FA-C21 (WP 0009, Figure 124)
Proceed to Test Step 4.
terminal 15 and FA-C20 (WP
0009, Figure 113) terminal 70.
Ohms.
Test Step 4. Test for Open Cab
Lower Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) from cab
lower wiring harness P-C69 (WP
0009, Figure 46).
Resistance Less Than 5.0 Ohms -
sure resistance between cab
Rear chassis wiring harness is open,
lower wiring harness connector P-
replace rear chassis wiring harness
C69 (WP 0009, Figure 46) termi-
(WP 0188).
nal 47 and terminal 27.
Remove jumper wire between UA-C2
(WP 0009, Figure 192) terminal 2 and
Ohms.
terminal 3.
Connect the steering position sensor
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 5.
3. Using the MSD (WP 0006), select 2200-02 Code Active - Repeat
Implement 120M and verify 2200- troubleshooting code from the
02 is not active.
beginning.
2200-02 Code Not Active -
Troubleshooting complete.
0031-5