TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2152-03 Wheel Lean Control
Resistance 5.0 Ohms or Greater -
Position Sensor Voltage
Replace cab lower wiring harness
Above Normal - Continued
(WP 0266).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J1
(WP 0009, Figure 112).
Proceed to step 3.
3. Using MSD (WP 0006), select
2152-03 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
2152-03 is not active.
beginning.
2152-03 Code Not Active -
Troubleshooting complete.
Test Step 5. Test for Open Cab
Lower Wiring Harness.
1. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J1 (WP 0009, Figure 69)
(WP 0266).
2. Disconnect jumper wire between
cab lower wiring harness connec-
tor P-C51 (WP 0009, Figure 118)
terminal 3 and machine ground.
3. Connect jumper wire between cab
lower wiring harness connector P-
C51 (WP 0009, Figure 118) termi-
nal 1 and machine ground.
0028-41
