TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-02 Steering Control
Voltage OK (7.2 to 8.8 Volts) - 8 Volt
Position Sensor #2 Data
voltage between P-C51 terminal 1
power supply from implement ECM
Erratic, Intermittent or Incor-
(WP 0009, Figure 118) and termi-
and cab lower wiring harness OK,
rect - Continued
nal 8 (ground).
proceed to step 5.
Voltage should be 7.2 to 8.8 volts.
Voltage NOT OK - Proceed to Test
Step 3.
Voltage OK (11.8 to 12.3 Volts) -
voltage between P-C51 terminal 7
Sensor signal circuit, transmission
(WP 0009, Figure 118) and termi-
and implement ECM OK. Replace LH
nal 8 (ground).
joystick (WP 0282).
Voltage should be 11.8 to 12.3 volts.
Proceed to step 6.
Voltage Not OK - Sensor signal
circuit shorted or transmission or
implement ECM bad, proceed to Test
Step 4.
6. Using the MSD (WP 0006), select 1472-02 Code Active - Repeat
Implement 120M and verify 1472- troubleshooting code from the
beginning.
02 is not active.
1472-02 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Cab
Lower Wiring Harness to 8 Volt
Power Supply.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Connect jumper wire between P-
C51 terminal 1 and terminal 8
(WP 0009, Figure 118).
3. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
0027-73