TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0597-04 Main Hydraulic
2. Using digital multimeter, measure
Continuity - Replace hydraulic valve
Pump Discharge Pressure
for resistance between hydraulic
wiring harness (WP 0190).
Sensor Voltage Below
valve wiring harness connector
Connect the rear chassis wiring
Normal - Continued
AP-C1 (WP 0009, Figure 213) ter-
harness connector FA-C22 (WP 0009,
minal 3 and terminal 2.
Figure 47) to cab lower wiring harness
There should be no continuity.
connector P-C69 (WP 0009, Figure
46) (WP 0188).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 3.
No Continuity - Replace rear chassis
wiring harness (WP 0188).
Connect the hydraulic valve wiring
harness connector AP-C2 (WP 0009,
Figure 214) to hydraulic pump
discharge pressure sensor.
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 3.
3. Using the MSD (WP 0006), select 0597-04 Code Active - Repeat
Implement 120M and verify 0597- troubleshooting code from the
04 is not active.
beginning.
0597-04 Code Not Active -
Troubleshooting complete.
0026-83