TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-08 Right Steering Cyl-
Test Step 3. Test for Open Rear
inder Position Sensor
Chassis Wiring Harness.
Abnormal Frequency, Pulse
1. Turn ignition switch and battery
Width or Period - Continued
disconnect switch to the OFF
position.
2. Disconnect UA-C2 (WP 0009,
Figure 192) from right steering
position sensor (WP 0009, Figure
197).
3. Disconnect UC-C2 (WP 0009,
Figure 196) from left steering
position sensor (WP 0009, Figure
193).
4. Connect the steering position
sensor harness UA-C2 (WP 0009,
Figure 192) to left steering posi-
tion sensor (WP 0009, Figure
193) (WP 0169).
5. Disconnect the rear chassis wir-
ing harness connector FA-C21
(WP 0009, Figure 124) from
transmission ECM J2 (WP 0009,
Figure 112).
6. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J-2 (WP 0009, Figure 71)
(WP 0268).
7. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
8. Connect jumper wire between
UC-C2 (WP 0009, Figure 196)
terminal 2 and machine ground.
9. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between rear chassis
Proceed to Test Step 7.
wiring harness connector FA-C21
Resistance 5.0 Ohms or Greater -
(WP 0009, Figure 124) terminal
Proceed to Test Step 4.
16 and machine ground. Resis-
tance should be less than
5.0 Ohms.
0020-107
