TM 5-3805-293-23-1
0018
Table 1. Transmission Code (1326-02 to 1408-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1407-05 Transmission Sole-
noid 7 Current Below Nor-
resistance between transmission
Rear chassis wiring harness is open,
mal - Continued
wiring harness connector T-C10
replace rear chassis wiring harness
(WP 0188).
and terminal 5. There should be
Remove jumper wire from T-C3 termi-
180).
Connect transmission harness con-
transmission clutch modulating valve
Proceed to step 3.
Transmission wiring harness is open,
replace transmission wiring harness
(WP 0158).
Connect the rear chassis wiring har-
Figure 113) to transmission ECM J1
Proceed to step 3.
1407-05 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1407-05 is not active.
1407-05 Code Not Active - Trouble-
shooting complete.
1407-06 Transmission Sole-
System Response:
noid 7 Current Above Nor-
ECM will log a diagnostic code and a
mal
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for Shorted Trans-
mission Clutch Modulating Valve.
Trans/chassis 120M and verify
1407-06 is active.