TM 5-3805-293-23-1
0018
Table 1. Transmission Code (1326-02 to 1408-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1403-05 Transmission Sole-
2. Using digital multimeter, measure
Resistance Less than 5.0 Ohms -
noid 3 Current Below Nor-
resistance between transmission
Rear chassis wiring harness is open,
mal - Continued
wiring harness connector T-C10
replace rear chassis wiring harness
(WP 0009, Figure 168) terminal 3
(WP 0188).
and terminal 5. There should be
Remove jumper wire from T-C2 termi-
nal 1 and terminal 2 (WP 0009, Figure
172).
Connect transmission harness con-
nector T-C2 (WP 0009, Figure 172) to
transmission clutch modulating valve
3 (WP 0009, Figure 173) (WP 0155).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Transmission wiring harness is open,
replace transmission wiring harness
(WP 0158).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J1
(WP 0009, Figure 112).
Proceed to step 3.
3. Using the MSD (WP 0006), select
1403-05 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1403-05 is not active.
1403-05 Code Not Active - Trouble-
shooting complete.
0018-23