TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0622-03 Upshift Switch Volt-
4. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
age Above Normal - Contin-
continuity between harness con-
ceed to step 5.
ued
nector P-C48 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
116) terminal 3 and harness con-
Replace cab lower wiring harness
nector P-C69 (WP 0009, Figure
(WP 0266).
46) terminal 22.
Connect harness connector FA-C21
Resistance should be less than
(WP 0009, Figure 124) to transmis-
5.0 ohms.
sion ECM J2 (WP 0009, Figure 112).
Proceed to step 7.
5. Disconnect harness connector
FA-C20 (WP 0009, Figure 113)
from transmission ECM J1 (WP
0009, Figure 112) (WP 0137).
6. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Replace transmission ECM (WP
nector FA-C22 (WP 0009, Figure
0137).
47) terminal 28 and harness con-
Connect harness connector P-C41
nector FA-C20 (WP 0009, Figure
(WP 0009, Figure 68) to implement 1
113) terminal 21.
ECM J1 (WP 0009, Figure 69) (WP
Resistance should be less than
0268).
5.0 ohms.
Connect harness connector P-C51
(WP 0009, Figure 118) to left joystick
J1 (WP 0009, Figure 119) (WP 0282).
Connect harness connector P-C52
(WP 0009, Figure 154) to left hand
joystick J2 (WP 0282).
Connect harness connector P-C48
(WP 0009, Figure 116) to left joystick
J3 (WP 0009, Figure 117), and install
inner panel cover to left joystick sup-
port (WP 0282).
Install operator's seat (WP 0284).
Proceed to step 7.
0017-80