TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0622-03 Upshift Switch Volt-
6. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
age Above Normal - Contin-
continuity between harness con-
ceed to step 7.
ued
nector FA-C21 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
124) terminal 30 and terminal 31.
Replace rear chassis wiring harness
Resistance should be less than
(WP 0266).
5.0 ohms.
Proceed to step 16.
7.
Remove jumper wire from har-
ness connector FA-C22 (WP
0009, Figure 47) terminal 7 and
terminal 34.
8. Using digital multimeter, test for
Continuity - Replace rear chassis
continuity between harness con-
wiring harness (WP 0266).
nector FA-C21 (WP 0009, Figure
Proceed to step 16.
124) terminal 31 and all other ter-
No Continuity - Proceed to step 9.
minals on harness connector FA-
C21.
There should be no continuity.
9. Remove operator's seat (WP
0284).
10. Remove inner panel cover from
left joystick support (WP 0282).
11. Disconnect harness connector P-
C52 (WP 0009, Figure 154) from
left hand joystick J2 (WP 0282).
12. Install jumper wire between har-
ness connector P-C52 (WP 0009,
Figure 154) terminal 5 and termi-
nal 6.
13. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
continuity between harness con-
ceed to step 14.
nector P-C69 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
46) terminal 7 and terminal 34.
Replace cab lower wiring harness
Resistance should be less than
(WP 0266).
5.0 ohms.
Connect harness connector P-C52
(WP 0009, Figure 154) to left hand
joystick J2 (WP 0282).
Install inner panel cover to left joystick
support (WP 0282).
Install operator's seat (WP 0284).
Proceed to step 16.
14. Remove jumper wire from har-
ness connector P-C52 (WP 0009,
Figure 154) terminal 5 and termi-
nal 6.
0017-76