TM 5-3805-293-23-1
0015
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2322-02 Right Front Drive
3. Using a digital multimeter, mea-
Voltage Greater Than 0.3 Volts on
Motor Speed Sensor #2
sure voltage between P-C35 ter-
One or More Test Points - Replace
Data Erratic, Intermittent or
minal 45 (WP 0009, Figure 53)
cab lower wiring harness (WP 0266).
Incorrect - Continued
and ground.
Connect AF-C1 (WP 0009, Figure
61) on AH-C1 harness connector
(WP 0009, Figure 62).
Install nose front frame cover and
rear front frame cover on machine
(WP 0224).
Connect AH-C2 (WP 0009, Figure
57) on right front drive motor speed
sensor connector (WP 0009, Figure
58) (WP 0166).
Proceed to step 4.
Voltage 0.3 Volts or Lower on Both
Test Points - Replace AWD ECM
(WP 0270).
Connect AF-C3 (WP 0009, Figure
51) on P-C34 (WP 0009, Figure 52)
(WP 0200).
Install rear front frame cover on
machine (WP 0224).
Connect AF-C1 (WP 0009, Figure
61) on AH-C1 harness connector
(WP 0009, Figure 62).
Install nose front frame cover on
machine (WP 0224).
Connect AH-C2 (WP 0009, Figure
57) on right front drive motor speed
sensor connector (WP 0009, Figure
58) (WP 0166).
Proceed to step 4.
4. Perform Speed Sensor Test (WP
Motor Speeds Not OK, 2322-02
0023) and verify motors speeds
Code Active - Repeat
are 920 50 rpm in forward and -
troubleshooting code from the
920 50 rpm in reverse.
beginning.
Motor Speeds OK and 2322-02
Code Not Active - Troubleshooting
complete.
Test Step 11. Test for Shorted
Right Motor Speed Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
0015-67