TM 5-3805-293-23-1
0015
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2322-02 Right Front Drive
Test Step 5. Test 8-Volt Return Cir-
Motor Speed Sensor #2
cuit for High Resistance or Open
Data Erratic, Intermittent or
in Cab Lower Wiring Harness.
Incorrect - Continued
1. Using a digital multimeter, mea-
Resistance 5.0 Ohms or Greater -
sure resistance between P-C35
Replace cab lower wiring harness
terminal 45 (WP 0009, Figure 53)
(WP 0266).
and P-C34 terminal 21 (WP
Connect AF-C1 (WP 0009, Figure
0009, Figure 52).
61) on AH-C1 harness connector
(WP 0009, Figure 62).
Install nose front frame cover and
rear front frame cover on machine
(WP 0224).
Connect AH-C2 (WP 0009, Figure
57) on right front drive motor speed
sensor connector (WP 0009, Figure
58) (WP 0166).
Proceed to step 2.
Resistance Less Than 5.0 Ohms -
Replace AWD ECM (WP 0270).
Connect AF-C3 (WP 0009, Figure
51) on P-C34 (WP 0009, Figure 52)
(WP 0200).
Install rear front frame cover on
machine (WP 0224).
Connect AF-C1 (WP 0009, Figure
61) on AH-C1 harness connector
(WP 0009, Figure 62).
Install nose front frame cover on
machine (WP 0224).
Connect AH-C2 (WP 0009, Figure
57) on right front drive motor speed
sensor connector (WP 0009, Figure
58) (WP 0166).
Proceed to step 2.
Motor Speeds Not OK, 2322-02
2. Perform Speed Sensor Test (WP
Code Active - Repeat
0023) and verify motors speeds
troubleshooting code from the
are 920 50 rpm in forward and -
beginning.
920 50 rpm in reverse.
Motor Speeds OK and 2322-02
Code Not Active - Troubleshooting
complete.
0015-61