TM 5-3805-293-23-1
0015
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2319-02 Left Front Drive
3. Using a digital multimeter, mea-
Voltage Greater Than 0.3 Volts on
Motor Speed Sensor #1
sure voltage between P-C35 ter-
One or More Test Points - Replace
Data Erratic, Intermittent or
minal 45 (WP 0009, Figure 53)
cab lower wiring harness (WP 0266).
Incorrect - Continued
and ground.
Connect AF-C2 (WP 0009, Figure
63) on AK-C1 (WP 0009, Figure 64).
Install nose front frame cover on
machine (WP 0224).
Connect AK-C2 (WP 0009, Figure
59) on left front drive motor speed
sensor connector (WP 0009, Figure
60) (WP 0166).
Proceed to step 4.
Voltage 0.3 Volts or Lower on Both
Test Points - Replace AWD ECM
(WP 0270).
Connect AF-C3 (WP 0009, Figure
51) on P-C34 (WP 0009, Figure 52)
(WP 0200).
Install rear front frame cover on
machine (WP 0224).
Connect AF-C2 (WP 0009, Figure
63) on AK-C1 (WP 0009, Figure 64).
Install nose front frame cover on
machine (WP 0224).
Connect AK-C2 (WP 0009, Figure
59) on left front drive motor speed
sensor connector (WP 0009, Figure
60) (WP 0166).
Proceed to step 4.
4. Perform Speed Sensor Test (WP
Motor Speeds Not OK, 2319-02
0023) and verify motors speeds
Code Active - Repeat
are 920 50 rpm in forward and -
troubleshooting code from the
920 50 rpm in reverse.
beginning.
Motor Speeds OK and 2319-02
Code Not Active - Troubleshooting
complete.
Test Step 11. Test for Shorted Left
Motor Speed Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Remove nose front frame cover
from machine (WP 0224).
0015-11