TM 5-3805-293-23-1
0014
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2295-03 Left Front Drive
Test Step 4. Test Left Front Drive
Pump Forward Control Sole-
Pump Forward Control Solenoid
noid Voltage Above Normal -
Circuit for Short to Other Circuits in
Continued
Cab Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
3. Disconnect cab lower wiring P-
C37 harness connector (WP
0009, Figure 55) from AWD ECM
J2 (WP 0009, Figure 56) (WP
0270).
4. Using a digital multimeter, test for
No Continuity - Proceed to step 5.
continuity between P-C35 termi-
Continuity - Replace cab lower wiring
nal 48 and all other circuits in P-
harness (WP 0266).
C35 (WP 0009, Figure 53). There
Connect AC-C5 (WP 0009, Figure 78)
should be no continuity.
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AX-C1 (WP 0009, Figure
100) on AC-C1 (WP 0009, Figure
101) and close access door.
Install front engine enclosure access
panel (WP 0226).
Proceed to step 6.
5. Using a digital multimeter, test for
No Continuity - Proceed to Test Step
continuity between P-C35 termi-
5.
nal 48 (WP 0009, Figure 53) and
Continuity - Replace cab lower wiring
all circuits in P-C37 (WP 0009,
harness (WP 0266).
Figure 55). There should be no
Connect AC-C5 (WP 0009, Figure 78)
continuity.
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AX-C1 (WP 0009, Figure
100) on AC-C1 (WP 0009, Figure
101) and close access door.
Install front engine enclosure access
panel (WP 0226).
Proceed to step 6.
0014-31