TM 5-3805-293-23-1
0011
Table 2. Engine Troubleshooting with Codes for the 120M Motor Grader - Continued.
CDI FMI CODE
ERROR/EVENT
CORRECTIVE ACTION
0006-05 Cylinder #6 Injector
Test Step 2. Isolate Problem with
Current Below Normal -
Engine Control Wiring Harness.
Continued
1. Turn ignition switch to the OFF
position.
2. Disconnect EA-C13 (WP 0009,
Figure 8) harness connector from
EH-C1 (WP 0009, Figure 9) at the
valve cover.
3. Install jumper wire at the EA-C13
(WP 0009, Figure 8) harness con-
nector between terminal 1 and
terminal 2.
4. Turn ignition switch to the ON
position.
N OT E
Wait at least 30 seconds in order for diagnostic codes to become active.
5. Start engine or attempt to start
engine.
6. At the MSD check that diagnostic
0006-06 Becomes Active - ECM and
code 0006-06 is active.
engine control wiring harness are OK,
proceed to Test Step 3.
0006-05 Remains Active - Proceed
to step 7.
7. Turn OFF the ignition and battery
disconnect switch.
8. Disconnect ECM harness
connector EA-C1 (WP 0009,
Figure 3) from Engine ECM J2.
9. Leave jumper wire at the EA-C13
Continuity - (Resistance less than
(WP 0009, Figure 8) harness con-
5.0 Ohms) - ECM faulty, replace
nector between terminal 1 and
engine ECM (WP 0067).
terminal 2 in place.
Remove jumper wire from EA-C13
(WP 0009, Figure 8) between terminal
1 and terminal 2.
Connect EA-C13 (WP 0009, Figure 8)
harness connector to EH-C1 (WP
0009, Figure 9) at the valve cover.
No Continuity - Proceed to step 11.
Change 1
0011-60
