TM 5-3805-293-10
0008
WARNING MESSAGE LABELS CONTINUED
WARNING DEFINITION
KEY
LABEL IDENTIFICATION
08
08
1
Seat Belt
A seat belt should be worn at all times during machine opera-
tion to prevent serious injury or death in the event of an acci-
dent or machine overturn. Failure to wear a seat belt during
machine operation may result in serious injury or death.
2
Do Not Weld On the ROPS/FOPS
Structural damage, an overturn, modification, alteration, or
Structure
improper repair can impair this structure's protection capability
thereby voiding this certification.
Do not weld on or drill holes in the structure. This will void the
certification.
This machine has been certified to the standards listed on
decal. Maximum mass of machine, which includes operator
and attachments without a payload, should not exceed mass
listed on decal.
3
Engine Coolant
Cooling system is pressurized. Hot coolant can cause serious
burns, injury, or death. To open the cooling system filler cap,
stop the engine and wait until the cooling system components
are cool. Loosen the cooling system pressure cap slowly in
order to relieve the pressure.
4
No Clearance
Stay back a safe distance. No clearance for a person in this
area when the machine turns. Severe injury or death from
crushing could occur.
5
No Clearance
Connect the steering frame lock between the front and the
rear frames before lifting, transporting, or servicing the
machine in the articulation area. Disconnect the steering
frame lock and secure the steering frame lock before
resuming operation. Severe injury or death could occur.
6
Accumulator
Cold ambient temperatures could result in loss of secondary
braking capability due to inadequate hydraulic accumulator
nitrogen pre-charge. Loss of secondary braking system as
well as main hydraulic pressure will result in little or no braking
capability.
Perform a brake accumulator check anytime machine has
been idle for longer than two hours below 13F (25C).
0008-5
