TM 5-3805-293-10
0006
TRAVELING AND EARTH MOVING OPERATIONS CONTINUED
Extreme Side Reach
0006
C AU T I O N
Make sure the blade is lowered to the ground before retracting the centershift lock pin.
Failure to follow this caution may result in damage to machine.
N OT E
The following steps are for extreme side reach to the right. For extreme left side reach,
position the centershift lock pin and blade to the far left.
1. Position the grader outside the working area of the project.
2. Circle the moldboard to 0 degrees to the grader frame and lower the moldboard to approximately 2 in. (50 mm)
above the ground.
3. Side shift the moldboard all the way to the right.
4. Centershift the circle assembly all the way to the right.
C AU T I O N
Lower the moldboard as needed to prevent metal-to-metal contact between the lift arm
and frame.
5. Lower the moldboard to the ground.
N OT E
Activating blade float will relieve all pressure from the moldboard.
6. Retract centershift lock pin.
7. Using right and left joysticks, position the centershift saddle to the far left centershift position.
8. Place the centershift lockpin into the far left centershift position.
N OT E
You may need to move the blade controls to completely seat the centershift lockpin.
9. Press the centershift lock switch to engage lockpin.
10. Raise the toe of the blade while lowering the heel as needed to bring the moldboard out to the right side of the
grader.
Circle the moldboard assembly to the right to the desired position.
11. Move centershift lock pin to far right position.
12. Sideshift blade to far right position.
13. Centershift circle assembly to far right position.
14. Circle the blade to the desired angle.
15. Lower blade to desired depth to deliver material to side.
0006-47