TM 5-3805-263-14&P-3
OPERATOR'S STATION
DECELERATOR
Depress the pedal (1) to temporarily decrease the engine
speed below the governor control setting. Release the
pedal (1) to resume governed speed.
HYDRAULIC CONTROLS
1. Blade lift (left side). 2. Scarifier. 3. Blade tip. 4.
Blade circle drive. 5. Blade sideshift.
1. Decelerator pedal.
HYDRAULIC UNLOADING VALVE
BLADE LIFT (LEFT SIDE)
When the ambient temperature is below 60F (160C),
Push the lever ( 1 ) forward to lower the left side of
depress and hold the control rod lever (1) down to
the blade.
reduce the load on the engine starter.
HOLD - The blade will not move.
Do not depress the control rod during normal operation
of the machine.
Pull the lever back to raise the left side of the blade.
SCARIFIER
Push the lever (2) forward to lower scarifier to the
ground.
HOLD - The scarifier will not move.
Pull the lever (2) back to raise the scarifier.
BLADE TIP
Push the lever (3) forward to tilt blade toward the
front of the machine.
1. Unloading valve.
HOLD - The blade will not move.
Pull the lever (3) back to tilt the blade to the rear of
the machine.
4-7
