TM 5-3805-261-34
Section I.
ENGINE TROUBLESHOOTING.
3-1.
GENERAL INFORMATION. This section lists the common engine malfunctions which may occur during the
operation of the 130G. You should perform the tests, inspections and corrective actions in the order listed. Follow the
troubleshooting procedures listed below step-by-step until you can go no further.
3-2.
ENGINE TROUBLESHOOTING PROCEDURES. This section cannot list all possible malfunctions, nor can it list
all possible tests, inspections or corrective actions. If a malfunction is not listed, contact your supervisor.
ENGINE TROUBLESHOOTING AND MAINTENANCE PROCEDURES.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
a.
ENGINE WILL NOT START.
Step 1.
Check for fuel in housing for the fuel injection pumps (Figure 3-1).
Figure 3-1.
If there is not enough fuel in housing, fill pumps with fuel with the priming pump. Remove air with the bleed valve.
Refer to paragraph 3-23.
Step 2.
Check the fuel injection timing.
If the timing is not correct--adjust. Refer to paragraph 3-7.
3-3
