TM 5-3805-261-34
WIRING AND HARNESS MAINTENANCE. (cont)
4-23.
Cab Main Harness. (Sheet 3 of 3)
INSTALLATION
CAUTION
Do not position main harness assembly
against any rough surface. Failure to
follow this procedure could cause chafing.
NOTE
Route main harness assembly exactly as
it was removed.
1.
Position cab main harness assembly (Figure 4-94).
2.
Position harness clip and mounting clips on cab
main harness assembly.
3.
Connect cab main harness assembly to cab fuse
box, cab signal lights, headlights and harnesses.
4.
Install mounting hardware on cab main harness
assembly mounting clips.
5.
Connect cab main harness assembly to rear wiper
switch. Refer to TM 5-3805-261-20.
6.
Install two plates behind right cab door hinge.
NOTE
Return 130G Grader to original
equipment condition.
End of Task
4-112
Figure 4-94.
