TM 5-3805-261-34
WIRING AND HARNESS MAINTENANCE.
4-23.
Cab Main Harness. (Sheet 2 of 3)
REMOVAL
1.
Remove two plates behind right cab door hinge.
Refer to TM 5-3805-261-20.
NOTE
All wire, cable and harness assemblies
must be tagged before disconnecting to aid
in installation.
2.
Disconnect cab main harness assembly from rear
wiper switch. Refer to TM 5-3805-261-20.
3.
Disconnect cab main harness assembly from cab
fuse box, cab signal lights, headlights, wiper motors
and harnesses (Figure 4-94).
4.
Remove cab main harness assembly mounting clips
and harness clip.
5.
Remove cab main harness.
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
1.
Inspect all parts. Refer to Chapter 2.
2.
Repair harness assembly, if necessary. Refer
to TM 5-3805-261-20.
Go to Sheet 3
4-111
Figure 4-94.