TM 5-3805-261-23-2
LEANING WHEEL CYLINDER REPAIR - CONTINUED
0304 00
ASSEMBLY - CONTINUED
NOTE
Use lubricating oil to lubricate outside of linear actuator cap assembly (14) and inside of cylinder.
11.
Install connecting link (6) inside cylinder (5).
NOTE
Connecting link rod must be fully extended before tightening cap. This will keep cylinder, piston, and head
in alignment.
12.
Tighten cap (14) and shaft collar (7) on cylinder (5) to
350 to 550 lb-ft (475 to 746 Nm).
5
6
14
7
397-1886
13.
Install two new bearings (2) centered on cylinder (4),
1
if removed, allowing installation of four new seals (1
and 3).
2
14.
Install four new seals (1 and 3) with lips facing out-
ward.
3
1
4
2
397-4205
3
15.
Install leaning wheel cylinder (WP 0156 00).
END OF WORK PACKAGE
0304 00-6