TM 5-3805-261-23-1
TRANSMISSION CONTROL ADJUSTMENT - CONTINUED
0150 00
TRANSMISSION MODULATION CONTROL ADJUSTMENT - CONTINUED
2.
Remove four bolts (23), washers (22), cover (24), and gasket (25) from housing (26). Discard gasket and remove all gas-
ket material from mounting surfaces.
26
22
25
23
24
397-440
3.
Remove bolt (31) and lockwasher (30). Discard lock-
washer.
27
4.
Push down rod end (28) until a noticeable resistance is
28
felt in the control cable (17).
29
5.
Loosen nut (29).
30
6.
Rotate rod end (28) in half-turn increments until hole
31
17
in rod end aligns with hole in lever (27).
7.
Install new lockwasher (30) and bolt (31).
397-441
8.
Tighten nut (29).
9.
Install new gasket (25), cover (24), four washers (22),
and bolts (23) on housing (26).
0150 00-6