TM 5-3805-261-23-1
DOME LIGHT DIMMER RESISTOR AND MOUNTING REPLACEMENT
(CCE MACHINE - CONTINUED
0100 00
REMOVAL
NOTE
Tag all wire and lead assemblies before disconnecting to aid in installation.
1.
Disconnect wire assembly (6) from connector (13).
2.
Remove shrinkable tube (3) and disconnect lead assembly (2) from resistor (5). Discard shrinkable tube.
3.
Remove shrinkable tube (3), lead assembly (2), and pin (11) from connector (13). Discard shrinkable tube.
4.
Remove shrinkable tube (3) and disconnect lead assembly (1) from resistor (5). Discard shrinkable tube.
5.
Remove shrinkable tube (3), lead assembly (1), and contact (12) from connector (13). Discard shrinkable tube.
6.
Remove connector (13) from bracket (7).
7.
Remove two rivets (4) and resistor (5) from bracket (7). Discard rivets.
8.
Remove nut (8), washer (9), bolt (10), and bracket (7).
6
2
3
4
5
3
1
7
12
9
8
13
11
10
397-301
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0021 00.
INSTALLATION
1.
Install bracket (7), bolt (10), washer (9), and nut (8).
2.
Install resistor (5) and two new rivets (4) on bracket (7).
3.
Install connector (13) on bracket (7).
4.
Install contact (12), connect lead assembly (1), and install new shrinkable tube (3) on connector (13).
5.
Install lead assembly (1) and new shrinkable tube (3) on resistor (5).
6.
Install pin (11), connect lead assembly (2), and install new shrinkable tube (3) on connector (13).
7.
Install lead assembly (2) and new shrinkable tube (3) on resistor (5).
8.
Connect wire assembly (6) on connector (13).
9.
Install right side panel in right side cab storage compartment (WP 0189 00).
10.
Install dome light switch (WP 0099 00).
11.
Connect battery cables (WP 0125 00).
END OF WORK PACKAGE
0100 00-2
