TM 5-3805-216-20
BODY, CAB, HOOD AND HULL MAINTENANCE.
13-20.
Hydraulic Drive Protection Cover. (Sheet 2 of 3)
REMOVAL
1.
Remove three bolts (1) and washers (2)
from shields (5 and 6, Figure 13-65) below
hydraulic tank.
2.
Remove two of four bolts (3), two of four
washers (4) and left shield (5).
WARNING
Only
a
qualified
operator
may
perform the next procedure. All other
personnel must clear the immediate
area. Failure to follow this procedure
may cause INJURY. If you are
injured,
seek
medical
aid
immediately.
3.
Start engine. Refer to TM 5-3805-261-10.
4.
Articulate vehicle full left.
5.
Stop engine.
6.
Remove two of four bolts (3), two of four
washers (4) and right shield (6).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter2.
Figure 13-65.
Go to Sheet 3
13-77