TM 5-3805-261-20Section I. BODY, CAB, HOOD AND HULL TROUBLESHOOTING.13-1.GENERAL INFORMATION.This section lists the common body, cab, hood and hull malfunctions which mayoccur during the operation of the 130G Grader. You should perform the tests, inspections and corrective actions in theorder listed. Follow the troubleshooting procedures listed below step-by-step until you can go no further.13-2.BODY, CAB, HOOD AND HULL TROUBLESHOOTING PROCEDURES. This section cannot list all possiblemalfunctions, nor can it list all possible tests, inspections or corrective actions. If a malfunction is not listed, contactyour supervisor.BODY, CAB, HOOD AND HULL TROUBLESHOOTING AND MAINTENANCE PROCEDURES.MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTIONa.CAB ROLLOVER PROTECTIVE STRUCTURE IS NOT SECURE.Step 1.Check ROPS mounting hardware (Figure 13-1).Figure 13-1.Tighten bolts where necessary.Step 2.Check strips on the bottom of ROPS assembly.If the strip are not sealed, or if they are damaged or defective--replace. Refer to paragraph 13-7.Step 3.Contact Direct Support.13-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
