TM 5-3805-261-20BRAKE MAINTENANCE.9-4.Service Brakes. (Sheet 2 of 3)ADJUSTMENT1.Fully release pedal (1, Figure 9-2) frombeneath floor plate on right side of cab.2.Check roller (2). Roller (2) must be slightlyin contact with plunger of brake controlvalve. A slight drag will be felt if roller (2) isturned.3.Clean stop (3) as required to make contact.Make sure there is no dirt between stop (3)and floor.4.Vent all air pressure. Refer to TM 5-3805-261-10.5.Loosen nut (4).6.Turn out screw (5). A slight drag must befelt when roller (2) is turned.7.Loosen nut (6).8.Turn stop screw (7) all the way down.9.Depress pedal (1) and hold until solid stopin valve is felt. This is maximum stroke ofvalve.Figure 9-2Go to Sheet 39-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
