Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
1471-14 Steering Control
Position Sensor #1 Special
ECM will log a diagnostic code and a
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for Other Codes.
Trans/chassis 120M and verify
1471-14 is active.
2. Check for Active code 1471-14
Code 1471-14 Active on Both
Trans/Chassis and Implement
ECMs - Proceed to Test Step 2.
Code 1471-14 Active on Trans/
Chassis ECM Only - Proceed to Test
Test Step 2. Test for Signal Voltage
at LH Joystick.
1. Turn ignition switch and battery
disconnect switch to the OFF
2. Disconnect the cab lower wiring
harness connector P-C51 (WP
0009, Figure 118) from LH joy-
Figure 119) (WP 0282).
3. Turn ignition switch and battery
disconnect switch to the ON posi-