TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures.
0017
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0573-03 Inching Pedal Posi-
System Response:
tion Sensor Voltage Above
ECM will log a diagnostic code.
Normal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0573-03
is Active.
1. Connect MSD. Select Trans/
0573-03 Code Active - Proceed to
Chassis 120M and verify 0573-03
Test Step 2.
is active.
0573-03 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test 8 Volt Sensor Sup-
ply Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect harness connector P-
inching pedal position sensor (WP
0009, Figure 115) (WP 0289).
3. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
Voltage Between 7.6 and 8.4 Volts -
Voltage Between harness con-
Proceed to Test Step 3.
Voltage Less than 7.6 Volts - Pro-
114) terminal A and machine
ceed to step 5.
ground.
Voltage should between 7.6 and 8.4
volts.
5. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
6. Remove cab bulkhead cover (WP
0266) from rear of cab.