TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1471-08 Steering Control
Test Step 3. Test for Open Cab
Position Sensor #1 Abnor-
Upper Wiring Harness.
mal Frequency, Pulse Width
1. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
or Period - Continued
resistance between cab lower wir-
Rear chassis wiring harness is open,
ing harness connector P-C69
replace rear chassis wiring harness
(WP 0009, Figure 46) terminal 49
(WP 0188).
and terminal 45.
Remove jumper wire between P-C51
Resistance should be less than 5.0
terminal 2 and terminal 4 (WP 0009,
ohms.
Figure 118).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 2.
Resistance 5.0 Ohms or Greater -
Cab lower wiring harness is open,
replace cab lower wiring harness (WP
0266).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) (WP 0154) to transmis-
sion ECM J1 (WP 0009, Figure 112).
Proceed to step 2.
2. Using the MSD (WP 0006), select
1471-08 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1471-08 is not active.
1471-08 Code Not Active - Trouble-
shooting complete.
Test Step 4. Test for Open Cab
Upper Wiring Harness to Imple-
ment ECM.
1. Remove jumper wire between P-
C51 terminal 2 and terminal 4
(WP 0009, Figure 118).
0019-19
