TM 5-3805-293-23-1
0018
Table 1. Transmission Code (1326-02 to 1408-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1401-05 Transmission Sole-
2. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
noid 1 Current Below Nor-
resistance between transmission
Rear chassis wiring harness is open,
mal - Continued
wiring harness connector T-C10
replace rear chassis wiring harness
(WP 0009, Figure 168) terminal 8
(WP 0188).
and terminal 10. There should be
Remove jumper wire from T-C9 termi-
nal 1 and terminal 2 (WP 0009, Figure
166).
Connect transmission harness con-
nector T-C9 (WP 0009, Figure 166) to
transmission clutch modulating valve
1 (WP 0009, Figure 167) (WP 0155).
Proceed to step 3.
Resistance 5.0 Ohms or More -
Transmission wiring harness is open,
replace transmission wiring harness
(WP 0158).
Remove jumper wire from T-C9 termi-
nal 1 and terminal 2 (WP 0009, Figure
166).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J1
(WP 0009, Figure 112).
Proceed to step 3.
3. Using the MSD (WP 0006), select
1401-05 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1401-05 is not active.
1401-05 Code Not Active - Trouble-
shooting complete.
0018-7