TM 5-3805-261-23-1
TOOLBOX REPLACEMENT - CONTINUED
0202 00
REMOVAL
NOTE
Toolbox may be mounted on right side panel or center of frame. Sectionalized machines have both triangular
and rectangular shaped toolboxes. Each toolbox configuration is shown.
1.
Select appropriate figure, following:
a.
Open lock(s) (7) and cover (3) of toolbox (4).
b.
Remove two nuts (6) and washers (5) from bottom of toolbox (4) at front corners.
c.
Remove four bolts (2) and washers (1) from inside toolbox (4) at each corner.
d.
Remove toolbox (4).
2
1
2
3
1
4
7
5
6
397-2487
0202 00-2
