TM 5-3805-261-23-1
CAB WINDOWS REPLACEMENT (CCE MACHINE) - CONTINUED
0187 00
REMOVAL
WARNING
When working with glass, always wear safety goggles and protective gloves. Failure to take precautions
could cause injury to personnel.
NOTE
This procedure covers replacement of the rear window glass. Follow these instructions for the upper-front
windshield glass, right and left side window glass, right and left-upper door window glass and right and left-
lower door window glass.
1.
Use seal installer tool (3) to unlock seal (2) in rear window, outside of cab. Place curved end of seal installer tool in
between locking lips (5) at butted ends (1) of seal. Work seal installer tool around circumference of window, pulling
locking lip away from cab.
2.
Remove glass (4). With assistance, tilt top of glass away from cab and remove from bottom channel.
3.
Remove and seal (2) by pulling out from edge of window opening. Discard if damaged.
2
1
3
4
397-589
5
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
INSTALLATION
1.
Install new seal (2). Start one end of seal on side of window opening, with locking lip (5) towards outside of cab.
2.
Push seal (2) on edge of window opening around circumference of opening until ends are closed together smooth and
tight. Cut bulk seal material 1/8 in. per foot (3 mm per 30.5 cm) of window opening circumference past starting point,
then close ends.
0187 00-2