SCREEN
FOLD
FOLD
NOTES:
1
FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW -10 F. Remove lubricants prescribed in the key for
temperatures above - 10F. Relubricate with lubricants specified in the key for temperatures below -10F.
2.
OIL CAN POINTS. Every 50 hours lubricate yoke pins, pivot pins, hinges and fasteners, control linkages, and all exposed adjusting threads with
OE/HDO.
3.
SCREEN SHAFT HOUSING GEAR BOXES. The gear box on the drives side of the unit has a capacity of 1 1/2 qts. The gear box on the gear
side of the unit has a capacity of 2 qt. To drain the gear boxes remove the drain plugs located on bottom of screen drive unit housing.
4.
WHEEL BEARINGS Every 1000 hours, remove wheels, inspect all parts, replace damaged or worn parts, repack bearings, and reassemble.
5.
LUBRICANTS: The following is a list of lubricants with the Military Symbols and applicable Specification numbers.
OE/HDO MIL-L-2104C
GOS MIL-L-10324
GO MlL-L-2105
GAA G-10924
Copy of this Lubrication Order will remain with the equipment at all times; instructions contained herein are mandatory.
BY ORDER OF THE SECRETARY OF THE ARMY:
CREIGHTON W. ABRAMS
General, United States Army
Chief of Staff
OFFICIAL:
VERNON L. BOWERS
Major General, United States Army
The Adjutant General
DISTRIBUTION: To be distributed in accordance with DA Form 12-25B (qty rqr block No. 913) operator maintenance requirements for Mixer, Bituminous.
LO5-3895-322-12-1
* U.S. GOVERNMENT PRINTING OFFICE: 1985-461-026/20012