Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
2201-04 Right Steering Cyl-
inder Position Sensor Volt-
ECM will log a diagnostic code and a
age Below Normal
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for other active
codes and Front End Alignment.
1. Connect MSD (WP 0006), select
0041-02 or 0041-03 Implement ECM
Trans/Chassis and check for
Code Active - Troubleshoot 1482-02
Active code 0041-02 or 0041-03.
or 1482-03 code first before
0041-02 or 0041-03 Code Not Active
- Proceed to step 2.
2201-04 Code Active - Proceed to
2. Connect MSD (WP 0006), select
Test Step 2.
Implement 120m AND verify
2201-04 is active.
Test Step 2. Test for Faulty Left
Steering Cylinder Position Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
2. Disconnect the steering position
sensor harness UA-C2 (WP 0009,
Figure 192) from left steering
position sensor (WP 0009, Figure
193) (WP 0169).
3. Disconnect the steering position
sensor harness UC-C2 (WP
0009, Figure 196) from right
steering position sensor (WP
0009, Figure 197) (WP 0169).
4. Connect UA-C2 (WP 0009, Figure
192) to right steering position sen-
sor (WP 0009, Figure 197).