Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
2201-02 Right Steering Cyl-
inder Position Sensor Data
ECM will log a diagnostic code and a
Erratic, Intermittent or Incor-
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for other active
codes and Front End Alignment.
1. Connect MSD (WP 0006), select
0041-02 or 0041-03 Implement ECM
Trans/Chassis 120M and check
Code Active - Troubleshoot 1482-02
for Active code 0041-02 or 0041-
or 1482-03 code first before
0041-02 or 0041-03 Code Not Active
- Proceed to step 2.
2. Using MSD (WP 0006), select
Implement 120M and verify 2201-
02 is active.
3. Perform Axle Toe-In (Front)
Toe-In is Correct - Proceed to Test
Adjust (WP 0044).
Toe-In Required Adjustment -
Proceed to step 4.
4. Using the MSD (WP 0006), select 2201-02 Code Active - Repeat
Implement 120M and verify 2201- troubleshooting code from the
02 is not active.
2201-02 Code Not Active -
Test Step 2. Test for Faulty Left
Steering Cylinder Position Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF