Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
2151-08 Blade Right Lift
Lever Position Sensor
ECM will log diagnostic code.
N OT E
Width or Period
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Test for Active Code.
1. Connect MSD (WP 0006). Select
1482-03 or 1482-04 Code Active -
Implement 120M ECM and check
Troubleshoot 1482-03 or 1482-04
if 1482-03 or 1482-04 is active.
code first before proceeding.
1482-03 or 1482-04 Code Not Active
- Proceed to step 2.
2. Using the MSD (WP 0006). Select 2151-08 Code Active - Proceed to
Implement 120M and verify 2151- Test Step 2.
08 is active.
2151-08 Code Not Active -
Test Step 2. Test Signal Voltage to
1. Turn ignition switch and battery
disconnect switch to the OFF
2. Disconnect cab lower wiring har-
ness connector PE-C8 (WP 0009,
Figure 50) from RH joystick con-
nector J1 (WP 0283).
3. Turn ignition switch and battery
disconnect switch to the ON posi-
Voltage Between 13.5 to 14.5 Volts -
voltage between harness connec-
Replace RH joystick (WP 0283).
tor connector PE-C8 (WP 0009,
Proceed to step 5.
Figure 50) terminal 2 and terminal
Voltage Out of Specifications of
3. Voltage should be between
13.5 to 14.5 Volts - Proceed to Test
13.5 to 14.5 volts.