Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
2147-03 Automatic Neutral
Articulation Switch Voltage
ECM will log diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Test for Active Code.
Using the MSD (WP 0006). Select
2147-03 Code Active - Proceed to
Implement 120M and verify 2147-03
Test Step 2.
2147-03 Code Not Active -
Test Step 2. Test Automatic Neutral
1. Turn ignition switch and battery
disconnect switch to the OFF
2. Disconnect cab lower wiring har-
ness connector P-C51 (WP 0009,
Figure 118) from LH joystick con-
nector J1 (WP 0282).
3. Disconnect cab lower wiring har-
ness connector P-C52 (WP 0009,
Figure 154) from LH joystick con-
nector J2 (WP 0282).
4. With the automatic neutral articu-
Resistance Less Than 5.0 Ohms -
lation switch not depressed (TM
Proceed to step 5.
5-3805-293-10), using digital mul-
Replace LH joystick (WP 0282).
between LH joystick connector J1
Proceed to step 6.
(WP 0009, Figure 119) terminal 3
and J2 terminal 4.