Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
N OT E
1472-04 Steering Control
Position Sensor #2 Voltage
Always inspect the harness connectorsthat are involved in the circuit.
Below Normal - Continued
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for Signal Voltage
at LH Joystick.
1. Connect MSD (WP 0006), select
Implement 120M and verify 1472-
04 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
3. Disconnect the cab lower wiring
harness connector P-C51 (WP
0009, Figure 118) from LH joy-
stick connector J-1 (WP 0009,
Figure 119) (WP 0282).
4. Turn ignition switch and battery
disconnect switch to the ON posi-
Voltage OK (11.8 to 12.3 Volts) -
voltage between P-C51 terminal 7
Sensor signal circuit, transmission
(WP 0009, Figure 118) and termi-
and implement ECM OK. Replace LH
nal 8 (ground).
joystick (WP 0282).
Voltage should be 11.8 to 12.3 volts.
Proceed to step 6.
Voltage Not OK - Sensor signal
circuit shorted to ground or
transmission or implement ECM bad,
proceed to Test Step 2.
6. Using the MSD (WP 0006), select
1472-04 Code Active - Repeat
Trans/chassis 120M and verify
troubleshooting code from the
1472-04 is not active.
1472-04 Code Not Active -