Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
2200-02 Left Steering Cylin- 2. Using the MSD (WP 0006), select
2200-02 Code Active - Repeat trou-
der Position Sensor Data
Trans/chassis 120M and verify
bleshooting code from the beginning.
Erratic, Intermittent or Incor-
2200-02 is not active.
2200-02 Code Not Active - Trouble-
rect - Continued
2200-03 Left Steering Cylin-
der Position Sensor Voltage
ECM will log a diagnostic code and a
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for other active
1482-02 or 1482-03 Code Active -
1. Connect MSD (WP 0006), select
Troubleshoot 1482-02 or 1482-03
Trans/chassis 120M and check
code first before proceeding.
for Active code 1482-03 or 1482-
1482-02 or 1482-03 Code Not Active
and 2200-03 Code Active- Proceed
to Test Step 2.
Test Step 2. Test for Faulty Left
Steering Cylinder Position Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
2. Disconnect the steering position
sensor harness UA-C2 (WP 0009,
Figure 192) from left steering
position sensor (WP 0009, Figure
193) (WP 0169).
3. Disconnect the steering position
sensor harness UC-C2 (WP
0009, Figure 196) from right
steering position sensor (WP
0009, Figure 197) (WP 0169).