TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
System Response:
Voltage Above Normal
ECM will log a diagnostic code and a
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for Shorted Rear
Chassis Wiring Harness.
Trans/chassis 120M and verify
1674-03 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Disconnect the front chassis wir-
ing harness connector U-C39
ondary steering left solenoid (WP
0009, Figure 187) (WP 0216).
4. Disconnect the front chassis wir-
ing harness connector U-C40
0216).
5. Disconnect the rear chassis wir-
ing harness connector FA-C20
ure 112).