TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0967-02 Transmission/Chas- System Response:
sis Control Module Abnor-
ECM will log a diagnostic code.
mal Update Rate
Test Step 1. Verify if Code 0967-02
is Active.
0967-02 Code Active - Proceed to
Trans/Chassis 120M and verify
step 2.
0967-02 is active.
0967-02 Code Not Active - Trouble-
shooting complete.
2. Program the transmission ECM
0967-02 Code Active - Replace the
Trans/Chassis 120M and verify
transmission ECM (WP 0137) and the
0967-02 is not active.
Messenger (WP 0272).
0967-02 Code Not Active - Trouble-
shooting complete.
System Response:
0967-09 Monitoring System
Display Abnormal Update
ECM will log a diagnostic code.
Rate
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0967-09
is Active.
0967-09 Code Active - Proceed to
Trans/Chassis 120M and verify
Test 2.
0967-09 is active.
0967-09 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test Messenger Volt-
age Supply and Ground Circuits.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).