Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
2295-05 Left Front Drive
Pump Forward Control Sole- All-Wheel Drive (AWD) Electronic
noid Current Below Normal Control Module (ECM) will log a diag-
nostic code and a warning will appear
on the messenger while the diagnos-
tic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for Open Left
All Wheel Drive 120M and verify
2295-05 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
3. Open access door and disconnect
102) from left drive pump forward
4. Connect jumper wire between
AX-C2 terminal 1 and AX-C2 ter-
5. Turn battery disconnect switch
and ignition switch to the ON posi-