DISASSEMBLY AND ASSEMBLY
10. Install ring (21) in the lower groove in the
governor shaft. Install one sleeve (20) spring
(19), the other sleeve (20) and bearing (18) on
the governor shaft as shown.
NOTE: Spring (19) is used to put a preload on the
thrust bearing on the camshaft in the fuel injection
Use tool (C)to hold spring (19) in compression
and install ring (22) in the groove in the gover-
nor shaft. Remove tool (C).
Put lever (27) in position on governor servo
(23) and install pin (24) to hold the lever in
place. Use a hammer and chisel to move the
metal (stake) four places 90° apart on the out-
side surface on both legs of the governor servo
to hold pin (24) in place.
Install the O-ring seal on sleeve (25). Install
piston (26) and sleeve (25) in the governor
servo as shown.
Install valve (28) in the governor servo as
Install one lockring (32) in the groove near the
center of valve (28). Put sleeve (29), spring
(broken link spring) (30) and seat (3 1) in posi-
tion on valve (28) and install the other lockring
(32) to hold them in place.