DISASSEMBLY AND ASSEMBLY
When gear is installed, make sure the pins on
the gear engage the holes in the shaft.
6. Put gear (6) and bearing in position on the shaft
and install washer and bolt.
Clean water only is permitted for use as a lubri-
cant for assistance at installation. Do not dam-
age or put hands on the wear surface of the
carbon ring or the ceramic ring. Install the cer-
amic ring with the smoothest face of the ring
toward the carbon seal assembly.
7. Put the ceramic ring (7) in position in the rub-
ber seal. Use hand pressure and tool (which is
with the replacement ring) to install the cera-
mic ring and rubber seal.
8. Remove the spring from the seal assembly (8).
Use hand pressure and the tool (which is with
the replacement ring) to install the seal assem-
bly. Push seal assembly on the shaft until the
seal faces make light contact.
9. Install spring (9) on the seal assembly.