DISASSEMBLY AND ASSEMBLY
1. Clean all parts thoroughly before they are as-
sembled. Put clean engine oil on all parts.
2. Install snap ring (2), bearing (3) and snap ring
(1) in the cartridge housing.
3. Turn the cartridge housing over and install
snap ring (5), bearing (6) and snap ring (4).
4. Put seal ring (7) in position on the cartridge
5. Put seal ring (8) in position on collar (9).
6. Put bearing (10) in position on the collar.
NOTE: Bearing (10) must be installed on the collar
with grooved side up as shown.